1 Pair Terminal Block, VX 5 Point Connection Module, STB Module, Subscriber Terminal Block


Summit Telecom is China leading manufacturer provides 1 Pair Terminal Block, VX 5 Point Connection Module, STB Module, etc. in outside plant.
 
  • Description:
1. Item Code: ST VX-MD
2. 1 Pair Terminal Block is designed for mounting on a standard DIN rail and can therefore be mounted in a variety of housings in whatever quantities are required. The small footprint (2 cm wide) ensures a compact product.
3. 1 Pair Terminal Block provides a connection point between an exchange-side cable pair and a distribution pair.
4. VX 5 Point Connection Module incorporates a 5-point plug in module to provide continuity and a range of other options. Removal of the plug-in module does not disturb wire connections but makes contacts to them available for testing to both sides of the network.
5. VX 5 Point Connection Module (STB Module) is especially recommended for
a) Outdoor connections where the environmental conditions are extremely aggressive.
b) Terminations where user development characteristics require future flexibility in terms of the type of protection or filtering capabilities.
 
  • Size:

The maximum values are shown
 
  • Technical characteristics:
    Characteristics of the contact connection
    Connector of the distributive wire
 
Range of the section: diameter 0,4… 1,2 mm
Diameter on the isolation: it is maximal 5 mm
The current-response characteristics: 20 A (10 A on each conductor) during not less than 10 min, without the deformation of the module
Insulation resistance *  
“Dry” atmosphere: > 10 12 Ohm
“Moist” atmosphere (standard ASTM Of d618, procedure F): > 10 12[Om]
Salt fog: (standard ASTM Of b117) > 10 10 Ohm
Immersion beside the water: (15 days before 3% solution Of naCI) > 10 10 0[m]
The contact resistance  
R of material + R of the contact cross connection + by R of the contact connection of the wires < 10 m
Increase in the contact resistance  
After climatic testings: <2,5 m 
After 50 connections - turning offs: <2,5 m
Dielectric strength: >3 kV of direct current during 1 minute
 
  • Mechanical characteristics:
 
Pair/drop wire housing screw    Special passivated direct Iacquered Zamac alloy
Drop wire housing body Transparent polycarbonate
Body   V-0 glass-filter reinforced polycarbonate
Insertion contacts      Tinned phosphor bronze
Ground contacts Cu-Zn-Ni-Ag alloy
Continuity contacts Tinned hard brass
Lower sealant    Epoxy resin
Upper cable sealant Silicone fluid /Hot Melt Adhesive
Pair/drop wire bearing cover Polycarbonate
Plug-in module body  V-0 glass-fiber reinforced polycarbonate
Plug-in module sealant   Gel/Hot Melt Adhesive
“O”-ring       EPDM
Spring      Stainless steel
Cable/drop wire membrane    Thermoplastic rubber
 
  • Order Information:
1 Pair Terminal Block without Protection—ST VX-MD01
1 Pair Terminal Block with Overvoltage Protection—ST VX-MD02
1 Pair Terminal Block with Overvoltage and Overcurrent Protection—ST VX-MD02